Jun 15 2025
Overview Now that you’ve wired your STM32 Black Pill to an Arduino running JTAGenum and captured output via PuTTY, it’s time to make sense of the data. This part walks you through interpreting FOUND! lines, verifying the detected pins, and locking down a reliable JTAG configuration for future debugging. Step 9: Understanding the Output Format…..
Continue Reading
Jun 14 2025
Overview Now it’s time to automate discovery. We’ll use a tool called JTAGenum, which runs on an Arduino and probes the target’s pins to discover JTAG lines. In this step, you’ll set up an Arduino board with the JTAGenum firmware and wire it to the STM32. This allows you to scan multiple GPIO pins and…..
Continue Reading
May 10 2025
Welcome back! In this follow-up, we continue developing the STM32F411CE Lab 3 Challenge-Response system. Today we’ll cover:✅ Setting up STM32CubeIDE✅ Configuring JTAG, UART, GPIO✅ Adding challenge-response logic✅ Preparing for build, flash, and testing Step 1: Create the STM32CubeIDE Project Open STM32CubeIDE → File → New → STM32 Project Step 2: Select the MCU In the…..
Continue Reading
